Interested to Buy Any Domain ? << Click Here >> for more details...
what is different between synchronous & asynchronous motors
- 3 Answers
- 6662 Views
- I also Faced
- E-Mail Answers
Answer Posted / shy11am
synchronous motor
in synchronous motor the field is run at synchronous speed
with rotor speed.in this motor speed not depend on load.for
any load the speed will be constant.
Asynchronous motor
in Asynchronous motor the rotor run below the synchronous
speed.in this motor speed depend on load.for increase load
the speed will be change.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
how to measure the current by compact digital equipment with dislay which fit inside any equipment
Do closed loops systems require manual input?
how does a submersible pump work..?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
how to flameproof electrical motor on the shaft?
How isolater function when installed inelectrical 440V wiring
magnetizer priciple
Which motor will you choose which can operate in both lagging as well as leading power factors?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to calculate
