How many earthings are required for commissioning the
Transformer?
- 14 Answers
- 30889 Views
- Dalmia Group, HSL, I also Faced
- E-Mail Answers
Answer Posted / manoj kumar
total no of earthing is 5
where
lightining earthing
2 nos of boby earthing and neutral earthing
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
how to check regenerative load in drived motor
actually i can't understand what is 3dB ? and it's really not clear to me.please any one let it me be cleared.
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what is meant by surge? what we called for high currents?
what the function breaker failure scheme, how is it operated
What is order of the system?
What is polar plot?
Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?
What is power distribution criteria for converting single phase unbalanced residential load to 3 phase star connected balance system. Does total KW converted to 3 Phase. Means Divided by root 3.
explain all the classes with example
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
what is the use of power transformer in GSS.
How is the gain affected by the introduction of feedback in a control system.
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
