Interested to Buy Any Domain ? << Click Here >> for more details...
WHEN I AM CONNECTIN TWO ELCB IN PARALLEL.ONE ELCB
TRIPPED...HOW IT HAPPEND??
- 5 Answers
- 10961 Views
- I also Faced
- E-Mail Answers
Answer Posted / arvind
when you are connecting two ELCB parallel then its mean the
voltage between these will be same but not the current, so
which ever ELCB is connected to higher current side is
getting trip if the current is flowing greater than the set
value.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
what is per unit calculation?looking for simple and strong explanation thk u
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
What is a commutator?
What is an automatic controller?
in shunt clippers why a resistor is used in sereis with the input
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
On what basis the the size of Lightning arrester for buildings are selected ?
Define norton equivalent circuit?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
Why is better to have a minimum ceiling voltage of 250% than 160%?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
