What is the difference between AC Drives and DC Drives?
Answer Posted / abhas patel
drives are used only for motion control so if you are
talking about ac or dc drives then both are only used for
motor speed control by controlling ac or dc output voltage
DC drives are used for DC motors speed control whereas ac
drives are used for AC motors . Moreover DC drives have
only converter whereas ac drives have both converter and
inverter . in DC drives , thyristors are normally used for
converter whereas in Ac drives , thyristors/IGBT/ IGCT are
used dependong on the applications
DC drives performing the following functions:
1.speed control of DC motors
2.Breaking by applying resistance at rotor.
3.uses converter and chopper.
AC drives performing the following functions:
1.speed control of AC motors
2.Breaking/accelerating by changing the frequency of the
supply.
3.uses converter and inverter
Is This Answer Correct ? | 66 Yes | 19 No |
Post New Answer View All Answers
If you have an earth with pilecap then your resistance is really low. why and how?
star delta starter contorl circuit... drawing..
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
explain the types of drives
What is critical disruptive voltage?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
What test must you do before powering up a circuit that you have been working on?
how does a submersible pump work..?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
how to carried out DAR test in 11 KV Alternator ?
what is the difference between pvc & fiber glass cables
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
I am inpecting a 10kVA UPS what tests should i do and should i observe?