Interested to Buy Any Domain ? << Click Here >> for more details...
when we start the tube light, then it takes initially 1100
volt, after glow it takes 120 volt?(when we give 220 volt a.c.)
- 3 Answers
- 6604 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash gokhale
Normally bulb or tubes are filled up with some gases.
deionisation of such gases gives the light as a product of
collidation of gas particles. But for that deionasation
high energy is required and we use choke for the same.
Choke is a inductive device which takes more power for
starting.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how harmonics generated in induction furnance? how minimise it?
can the measured percentage error during calibration of single phase energy meter be negative?
What is force on a conductor in a magnetic field ?
Explain what is rated speed?
What is electrical cable termination
what is the value of combined earthing in general electrical circiut?
What is transmittance?
What are the transformer losses?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
what will happen if frequency is below 50 hz?
write a program that prints prime numbers from 1-20 in digonal form
Name the types of motors used in vacuum cleaners, phonographic appliances, vending machines,refrigerators, rolling mills, lathes, power factor improvement and cranes.
Explain Continuous and Discrete signals?
