Interested to Buy Any Domain ? << Click Here >> for more details...
why does mA signal preferred for signal transmission?
- 12 Answers
- 25973 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / deepak
ma signal is preffered because current signal does not drop
during transmission through sigal cable as comapred to
volatage signal but sometimes it gets affected by the stray
pickups that can e eliminated by connecting the shielding
at one end.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
How to calculate P,I&D value in PID controller ?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
what is intrinscily safe system and where we use?
how to calibrate corollaries (Mass flow meter)?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
all types of liquid analyzer principle with drawing?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is Span Error
What is 3 selection available when configure the burnout protection for controller
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Whatis the reset ofset and control system in instrumentation
Explain bernoulli’s theorem. State its application.
why using negative supply for bentley nevada vibration system ?
