Interested to Buy Any Domain ? << Click Here >> for more details...
What is the ratio of cement ,sand, and aggregate to be used
in M20 grade of concrete when excavating 200 x 200 x 200 mm
of sand from soil
- 4 Answers
- 9891 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagori salim
Ratio for M20 - 1:1.5:3
| Is This Answer Correct ? | 25 Yes | 1 No |
Post New Answer View All Answers
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
What are the causes of building collapse?
What is the significance of cost estimate knowledge for an architect?
why we are using stub column..? is it possible to construct steel stub column..?
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
Describe the various methods of concrete curing?
2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32
what is relation between SPT N value and driving piles after conducting a soil test?
Explain what are the phases inspections are done by local authority while construction?
Why is the use of granular sub-base in concrete carriageways not preferred, explain?
What is the compressive strength of fly ash bricks?
what is anchorage length,lap length and (dont remember the last one)
The portion of a brick cut across the width is called?
Which prize is the alternative to the NOVEL Prize?
Which are the Steel tests ?
