In pile foundation which kind of action are take place?
- 2 Answers
- 6098 Views
- I also Faced
- E-Mail Answers
Answer Posted / moula
end bearing action & friction action
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
If we buy crush sand for 3200/ Brass and cement for Rs350 /Bag and flyash 1200 / tonne....and my production is 230 Bricks per bag than how much cost is required for 1 flyash brick?
How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?
Explain what is zoning permit?
to draw bm diagrams for portal frames under different loadings//
a) Difference between Ghol , Chimney & fly ash bricks b)Floor to floor height is 3m , rise=15cm , tread 20 cm , how to design staircase means steps landing
What is specific gravity???
why the profile of shell of natural draught cooling tower is hyperabolic.
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
03. a. The water cement ratio for achieving maximum strength of concrete is…… 1 b. Water/ cement is inversely proportional to-------------- 1 c. Increasing the slump decreases the strength: True / false 1
What are the problems one might face while having a Cantilever balcony?
Dear Sir I Mahesh C. Bhamre have already given a Exam for Superintendent Officer / Public relation Officer Exam Dharmday Aaukta held at Nashik on Date 29/08/2010. My seat no was 5040247. and my cell no is 9822677994. and my mail Id is - mahesh.bhamre@rediffmail.com So can you pl send me details of result of respective exams. Thanking you in Anticipation.
what is the breaking strength of wall tiles
Which IS Code/American Code applied for coupler test of steel
if dia of inner circle is 42 m and depth is 1.5 m and width is 1 m ,then whait is the quantity of steel?
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
