We have AC-transformer 110/13.8kv,40MVA.If DC-Voltage=110kv
is applied in its primary what will happen?

Answer Posted / prabhakar

since the primary winding is of thin guage with large no.
of turns as compared to its secondary winding i.e.,the
resistance of the primary winding will be more and so that
no more short circuit happens with the winding and
eventually no more secondary voltage appears at the
secondary.(as per the basic of transformer principle)

Is This Answer Correct ?    1 Yes 2 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

how single phase preventer works ?

2025


List the characteristics of filter?

626


for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?

1540


If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????

1456


HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.

1763






ht side line to earth voltage

1079


what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing

2182


can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?

2802


In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

362


How to decide DO set rating of Transformer?

1163


WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT

2696


State the formula for overall efficiency of thermal power station

2551


what is meant by brushed alternator & its working principle ?

1550


Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?

654


what is the use of expulsition protective gap in 11Kv line.

1688