Interested to Buy Any Domain ? << Click Here >> for more details...
where do we connect tap of tap changer, to H.V. side or
L.V.side? and why?
- 5 Answers
- 14784 Views
- Vedanta, I also Faced
- E-Mail Answers
Answer Posted / thiyagarajan
because in lv sides current will be very high it is
difficult for the switching contacts carry higher currents
so tap changers will be always used in hv sides
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
what is differant beetween overload current and phase current?
At what speed 1 HP motor can run an electric car of weighing 400 kg?
What is float cum boost charging system?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
What is online and offline ups? how does it works?
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
What are the different types of hydro schemes?
3phase motor can be used as a Prime mover for alternator.
On 400 amp factory load how kvarh capacitors provide
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
which VFD is better ( LT or HT)
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
