Answer Posted / kapil narayanrao bahadure
Transformer works on the principal of mutual
induction.Transformer cannot work on dc supply because dc
voltage has no frequency. when dc supply give to
transformer then dont produced alternating magnetic flux &
also not cut to secondory winding.by air gap.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
what happen ehen synchronisation is done at below rated speed
how does WTI work ?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
specific difference of ICT&Auto Transformer
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
Why do we use copper cable for HT Supply and why not Aluminium?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What is an iron loss or core loss pi?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
State ohm’s law?
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
