Interested to Buy Any Domain ? << Click Here >> for more details...
Initially motor starts with star connection ,after few
timing changes to delta connection, why the motor should
run continously in star connection,it gives high torque &
low current?
- 3 Answers
- 9671 Views
- I also Faced
- E-Mail Answers
Answer Posted / marikkani.m
The purpose of starter is to start the motor and to limit
the starting current.we are starting the motor in y-
connetion during this impedence of two windings put across
the line voltage hence the starting current gettinh
redeuced
but the motor rated capacity (out put torque)can only be
obtained when itis changed to delta connection this time
the voltage is incresed bu 1.732 time to meet the torque
(torque is direct proportion to square of supply voltage .
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Explain what is use of lockout relay in ht voltage?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Dear all i am kumaravel. now in chennai. my work is control and relay panel auto cad designing.up to 11kv to 400kv then question is i am improving my knowledge. i want some books name and auther are available for this C&R panel related. plese any one help me
What is meant by a stray loss of a induction motor??? What is the equation to find it
What is the comparison of PILC and XLPE cable
What is the type of earth fault protection used in battery? explain.
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
why you don not show protection and type of isolation in key single line diagram?
