why we are not earthing ht cable at both the ends(sending &
receiving end)?
- 5 Answers
- 12425 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / ajit rath
If we connect both end to earth then potentional difference
will high & more circullating current will flow .
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Efficient electrical earthing in hard rock area
what is circuit breaker in transfomer and where it used
What is the difference between PLC and Embeded system
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
Why GRR starts from 60% of motor speed why not less than 60%?
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
describe the phenomena of vacuum interruption in C.B
When we use 3 terminal resistor?
what is the Pickup/drop off ratio in BCPU relays
how 650 volts creates? where is use?
How to synchronization will be done between two DGs ?
How can we convert 11 kv to 440 volt without using transformer ?
What is Load sharing of Transformer ?
