Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rites
Breakers are designed for various breaking capacity which
in turn is related to arc quenching media.
VCB - vaccum is the arc quenching media and hence can break
high current high voltage supply and hence used in medium
voltage 11/22kv.
ACB - Air is the quenching media and hence used in LT side
i.e 415 v circuits.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
george phenomenon of synchronous machine
What is steady state response?
what is effect of 5amp fuse on 2mva pry protection of transformer
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
When we use 3 terminal resistor?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
What is the size of a 60 watt and 80 watt tubelight?
what are factors to be consider to design a HT & LT motor?
In CTs tan delta point should be earthed , what is the reason behind it?
How to discuss the phase shift of transformer considering open delta?
Why is water motor not taking the pressure? what is the problem?
i am going to give the JSEB,RANCHI exam for power plant,so i need some samples of papers related to that,so please send me these papers by my mail id.
Why derivative controller is not used in control systems?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
