how we can calculate power factor without knowing current in
230v 100w load ?
- 10 Answers
- 17448 Views
- I also Faced
- E-Mail Answers
Answer Posted / gnaneshwar
without knowing current we cannot find the powerfactor.As per
question we have voltage v=230 and power p=100w as per
ohm'slaw p=vi,so I=p/v you'll get current then powerfactor=p/vI
| Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
explain supply side and demand side energy management with advantages & disadvantages
What are the difference between normal application Transformer and Solar application Transformer?
What is Load sharing of Transformer ?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is the Surge suppresor? Why using in a UDB's and How it works?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
what is the reactive power what is the use of it in system
While converting delta into star or star into delta ,the three values of resistances remains unchanged .Find out the value?Let In star R1=x;r2=x;R3=x On converting into delta,R12=x;R23=x;R31=x Find the value of x
how works inductive &capacitive sensors?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
Explain difference between stand by earth fault and residual earth fault protection?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
what is p.s impedance measurement test in earthing transformer?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
