Interested to Buy Any Domain ? << Click Here >> for more details...
1.what is use of isolation transformer.
2.Differance between KWH,KVAH,KVARH,KVA.
3.Main use of the CT and PT.
- 1 Answers
- 9353 Views
- I also Faced
- E-Mail Answers
Answer Posted / bilal hamad
1- to isolate supply and load in case of faults and power harmonics (to protect the source) and also to protect the load .
2-KWH: the real power (useful) consumption per hour.
KVAH: the total power consumption per hour.
KVA: the total power (real and imaginary)(vectors sum).
KVARH: the imaginary power consumption per hour.
in summary: the power factor will control the amount of real (active)power and reactive power. all real loads are usually inductive loads or resistive, this will reduce the power factor and then increase the reactive power, the solution is to install capacitor banks to increase the power factor and then reduce the reactive power so increase the active power.
3. CT: is a step down current transformer used for current measurement and protection.
PT or VT: is a step down voltage transformer used for voltage measurement.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Why are lt windings placed near the core?
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
What the main causes of transient interruptions on Over-Head Distribution Lines?
How you calculate the repturing capacity of a HRC fuse
why swityard is necessrry requirement in any bis power distributin systems?
if we have 320KVA Genset kindly advice how much load we can put it.
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
What are the functions of different probes used in cro?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
sir plz send some previous year questions of jspl.
How can we calculate the motor frame sizes?
Why the field rheostat is adjusted such that the voltmeter reads 380V
