What's the part of OTCC in transformer?
- 7 Answers
- 20611 Views
- Bhel, RRB, I also Faced
- E-Mail Answers
Answer Posted / d.sanadi
OTCC??? it should be either OCTC(OFF CIRCUIT TAP CHANGER)
OR OLTC (ON LOAD TAP CHANGER). Tap changers are basically
used to adjust the secondary voltage to a range of +/-5%
| Is This Answer Correct ? | 21 Yes | 2 No |
Post New Answer View All Answers
how can i get the formula to find out the cable size if i know the load of main fuse protection.
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
how is the testing of an REF relay? what are the test REF circuit having?
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
how to calculate cable size in diffrent loads?
what is the difference between electrical choke and electronic choke?
TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.
What is the difference between resistance grounding system and resistance earthing system?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
Give some example of fault limiting devices?
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
What is grid collapse? what is the reason for it?
how to calculate the distance relay faulty zone?pls explain?
