Interested to Buy Any Domain ? << Click Here >> for more details...
How can calculate ups battery back up time?
- 25 Answers
- 168616 Views
- Cisco, Cooper, Pronet, Wipro, I also Faced
- E-Mail Answers
Answer Posted / sss
UPS Backup=Battery Voltage*Battery Ah/Load (watt)
| Is This Answer Correct ? | 98 Yes | 47 No |
Post New Answer View All Answers
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
how to decide the panel size like MDB ,SMDB PANEL SIZES
What type of pipe material G.I or M.S is used for sprinkler system?
how mass curve differs from hydrograph.
WHAT IS LOAD CELL
how to make an earthing certificate
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
When MICC cables used ?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
