Interested to Buy Any Domain ? << Click Here >> for more details...
why we have to do tan delta test of the transformer oil???
- 5 Answers
- 18347 Views
- I also Faced
- E-Mail Answers
Answer Posted / vels
to determaine the insulation condition if the tan delta
value is higher than 0.7 for a transformer,then oil has to
be tested in all aspects .from the oil results we can under
stand where the insultion is weaks
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
What type of fittings and electrical accessories can be install in radiation area ?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
HOW TO CALCULATE EARTHING SIZING?
How can we checked Killo Watts of Motor & Alternator?
how to design the heater in temperature control unit to heat 50KL of water?
why current is constant on d.c?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What is the unit of attenuation?
what is two point starter?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
