Interested to Buy Any Domain ? << Click Here >> for more details...
What is the amount of no load current of 630 kVA tranformer
voltage ratio 11kV/440V ?
- 13 Answers
- 26869 Views
- I also Faced
- E-Mail Answers
Answer Posted / nilesh
630/19.05(11*1.732)=33.07amp
| Is This Answer Correct ? | 1 Yes | 14 No |
Post New Answer View All Answers
what is the best method of grounding in 30 MW generator?
advantages & disadvantages of Lagging and leading power factor .
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
what is the function of capacitor duty contactor in an capacitor panel???
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
difference between servo motor and synchronous motor
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
What is a differential amplifier?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
What is difference between safe PLC and normal PLC
How we calculate DC inducation moter Amp? Sir pls give me formula......
i want to know about torque of slip ring induction motor
