Interested to Buy Any Domain ? << Click Here >> for more details...
what is the reason of current flow in nutral although load
is balanced (three phase equal current)
- 3 Answers
- 6110 Views
- I also Faced
- E-Mail Answers
Answer Posted / shantanu dash
The neutral current in a balanced load condition flows due
to the third harmonics which is basically due to the use of
inverter drives, PLC etc. in the distribution system.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
Why do we perform an open-circuit test and short-circuit test on the transformer?
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Should power factor be low or high?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
What are the temperature elements?
what is the AC Plant and how can do the work with parts and picture tell us 150 Tr
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
Why transformer used in UPS??
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
what is 30-phase of transformer
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
