Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 358555 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / sabitha
sorry guys... mistake in the 1st line.... electrical is
the flow of electrons.....
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate power consumption in slip ring motor at different step
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Single line diagrams for star to delta and DOL starters.
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
what is the difference between b c d curves on mcb
Define sensitivity?
How is operate breaker failure scheme in substation
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
Explain in brief description about the operation of DG sets.
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
What is the instrument to check the rotating diode fuse of alternator in running conditions?
