Answer Posted / mehul g. c.

single phasing is the fault in that one of three phase will
break or not proper then machine or equipments will get
unbalance.

my mean to say is suppose r,y&b is three phase & y is not
showing voltage for some reason than it is single phasing.

if it is happens then machine will not work proper it will
get heated because of phase unbalancing or burnt.

What is the polarization index value ? (Pi value)and simple definition of polarization index ?

1215

---

An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.

1427

---

Is there any abbrevation for STUB in Stub bus protection

1942

---

If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.

1633

---

what happen if the parallel generator phase angle shift by 1 degree in manual mode

2056

---

How isolater function when installed inelectrical 440V wiring

2241

---

For overhead protection we use which transformer?

2493

---

Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz

2301

---

What is meant by Load Encroachment in OHL Feeder Protection?

3639

---

How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?

1084

---

state types of reflectors in illumination engg. ???????

1941

---

r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā

1718

---

In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)

11835

---

what is deffrence between squirral cage and wound rotor in IM?

1973

---

How we select the vector group of 3phase power transformer?

2737

---