Interested to Buy Any Domain ? << Click Here >> for more details...
Two CTs 1600/1 and 35/1 are in series. while checking the
ratio test of a CT(1600/1),same 1600A will also pass
through the CT having ratio 35/1.
Will it be harmfull to the ct(35/1),if yes , what will
happen.CT secondary is shorted
- 3 Answers
- 7376 Views
- I also Faced
- E-Mail Answers
Answer Posted / s ramar
The ratio is nominal one. The CT is required to measure
fault current which is very high. So nothing will happen to
the CT when 1600 A flows in the primary.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
in what type of applications v can use q meter?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
State and define norton’s theorem?
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
What is Servo Ventilated Motor?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
reason of diode failure in alternator
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
what is the electrical?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
how to calculate percentage impedence at 75 deg C at normal tap
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
