Interested to Buy Any Domain ? << Click Here >> for more details...
Why we Specify Transformer rating 433 V Instead of 415V
?
- 8 Answers
- 38637 Views
- ABB, ERA, Uddans, I also Faced
- E-Mail Answers
Answer Posted / sagar surve
Appliances rated voltage is 415V. If Trasformer is specied
at 415V, it will further drop down at receving end and
appliances may not work
| Is This Answer Correct ? | 15 Yes | 9 No |
Post New Answer View All Answers
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
What is the source of dependent source ?
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
Pleae send me last 5 years of Question book about RRB chennai.
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
What are the advantages of vscf wind electrical system?
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
What are the basic components of the feedback control system?
Why do we avoid electrical conduits in floors at apartments?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
