Answer Posted / santosh kawade

Transformer neutral in distribution transformer is earthed
because:
1) Keep neutral at zero potential,
2) keep all three phase voltage balance even if load is
unbalance,
3) to provide return path for current in case of earth
fault condition,

Santosh Kawade
9224 69 3116

What are the two segments of nyquist contour.

1105

---

The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input

2257

---

Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?

1423

---

What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?

2223

---

How select ELCB for 32amp. socket having quantity 12Nos. We have to do this wiring in PLANT. Please Also explain the incoming cable specification.

1870

---

what is negative and zero impedance in 3 phase induction motor ??

2167

---

What is meant by rotor?

1269

---

EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?

1923

---

what is the thumb rule for determination resistance of resistor?

2312

---

in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter

2229

---

briefly explain the main blocks found in a microprocessor based system

2189

---

i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?

1896

---

how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???

2021

---

where the lexical paramater will use in fron end?

1862

---

What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)

1907

---