Interested to Buy Any Domain ? << Click Here >> for more details...
while doing the excitation current test on power
transformer what is the value of voltage to be applied?
Nomonal rated voltage or 10% of rated voltage? Is it
necessary to apply on high voltage side?
- 1 Answers
- 5878 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / guna
we have to apply three phase voltage only..bcoz,for
transformer rated voltage is 220kv not 230v.we can check in
l.v side also.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
what are the steps involved in generator load test?
what type of motor used to move a 1 ton gate? and relate ratings with load.
What are the common sources of energy?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What is nyquist contour?
Draw transformer phasor diagram.(full load,no load)
What are the basic & Majour problems in UPS ?
The screw thread commonly used for transmission of motion is one of the following types of threads
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
State angle criterion.
can we synchronize star system generators with delta system transmission line ? and how ?
how to select fuse rating for a 3-phase motor ???
