Interested to Buy Any Domain ? << Click Here >> for more details...
Why we didn’t feel electric shock in an electric train ??
- 10 Answers
- 29603 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / haresh
Because electricity is only passes through the conductors
which are not in touch to coaches of train, electricity
only passes through conductors to the generators, batteries
and all lighting equipments as we use it at our home. So no
feel of electrict shock in an electric train.
| Is This Answer Correct ? | 33 Yes | 19 No |
Post New Answer View All Answers
What are the various types of rotor used in the alternators?
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
hello if any one have papers vof hpcl or sail, plz send me
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
Why neutral cable carry current.
mccb service sittings be done?
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
what is the excess air in furnace
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
Can you explain about pole discrepancy scheme
if a.c supply is given to the motor,, what happen?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to increase or decrease speed in DC shunt motor by DC convertor
