Interested to Buy Any Domain ? << Click Here >> for more details...
Can HT cable(11kv cable) be used for 415V, 700A requirement.
- 5 Answers
- 13779 Views
- I also Faced
- E-Mail Answers
Answer Posted / mehul
we can't use h.t. cabel as l.t. cable.
because the cost of your h.t. cable is much higher han same
rating h.t. cable.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
how to changeover ups in this power failur time?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What are the classifications of heating element?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
limitation of conductor height on ground when we consider EMC
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
How to setting the volume of RTCC panel AVR (11kv) controller
Inverter. converter. Ups.MCB.solar.alternators. motors.
hi all i like to know vat is power plot in control systems also i want to know abt latest trends in electrical & electronics
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
