Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajesh
generally flow measurent using diffrential is based on
bernoulis theorem.i.e cofficient of dicharge*square root of
diffrentails pressure
| Is This Answer Correct ? | 29 Yes | 7 No |
Post New Answer View All Answers
Draw block digram for well head from well to shipping pump?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Why flow/pressure transmitter before control valve?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
Isometric drawings are generated during _________________ phase of a project
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
kindly sent some demo question and answer
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
how to calibrate corollaries (Mass flow meter)?
