What are causes of cracks in outside plaster of a building
and how we prevent it during constructions?
Answer Posted / sjtbehera
There is very little that you can do, to prevent a plaster
ceiling from cracking. If it's going to crack, there is
nothing you can do to avoid this. However, these cracks can
easily be repaired using
Fiberglas drywall tape and finishing it with drywall joint
compound.
I have probably made this repair sound easier than it is,
but there is another alternative. You could fill the crack
with a good paintable caulking. Make sure that the caulking
you use is paintable, some silicone-based caulking aren't
paintable. If the caulking can be painted over, it will
save paintable on the tube of caulking.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
Where can I get a Text Book on Design of Blast Resistant Buildings in PDF form.
In cement concrete how to check a quality of material also proportion of material at site ?
Form where IS456 is adopted in 1978?
pls mail some more tecnical qustions at msaranya2610@gmail.com
What is the absolute pressure scale?
Explain the Strength of brick?
what is Quantity of stone and sand required for one cubic meter of stone work (UCR)
Can we apply curing compound on ceiling (slab Bottom)
What is the use of water table & Kreb stone for drain
what is Short bored pile foundation.
What is gravity flow?
how to calculate the length diamond shaped striupps in column
what is the max. area can we apply the plate load test ?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
how to calculate Rate of analysis for 100 m3 Any ratio of concrete ? including labour