Answer Posted / napoleon lucky momoh
uninterrupted power supply.it will supply the power for some
time when power gone .
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
The shot circuit in any winding of transformer result? Explain
What is super thermal power plant? and how it will differ from normal thermal power plant
how to calculate transformer load?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Can I use star delta connected induction motor for dual supply voltage?
What is the difference between the transmission line and distribution line?
what is the minimum voltage require to injure our body?
explain different types of d.c motors?
How much ph is maintained of water resistance starter for slipring induction motor ?
Define delay time.
what is DRP panels?
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is contract demand in solar system?
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.