Interested to Buy Any Domain ? << Click Here >> for more details...
in star delta starter current is 1/3times the delta value
how?
- 2 Answers
- 6825 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit kumar singh
in delta conection motor is direct on line current is
controled by relay in curcuit starting current high so used
high tourq motor as conveyr belt drive,water pump.use for
low hp motor.
in star delta conection current is redused 1/square root of
three, havey hp motor for protection heating low current is
requrid so we use star delta starter. its used for high hp
motor.
component in delta- one contactor,fuse,pushbutoon off-
on,field coil,overload relay.
component in star-3 contactor,fuse,pushbutoon, under
voltage coil,overload relay
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
why don't we use the generator as a motor? and what will happen?
why ht cable end termination don't have a gland?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
Difference between drift current and diffusion current?
What's the difference between non break power supply and non break non short break power supply
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
c++ write a program to use a fuction call "max"which accepts an intger arrey of size5.as an arrument and return the larger and smallest of the arrey to main without changing. the original changing of the original position of the element of the arrey.
What is the earth treantment procedure?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What are the advantages and disadvantages of closed-loop control system?
do we use neutral grounding for resistive balanced load? if we use what happen?
Explain the working of variable frequency transformer?
whatis the commertial spec. of distribution boards ?
