Interested to Buy Any Domain ? << Click Here >> for more details...
Convert a pressure, level, flow, or temperature process
variable value into the appropriate pneumatic or electrical
value given different types of instruments.
- 6 Answers
- 22873 Views
- Jindal, MCL, Thermax, I also Faced
- E-Mail Answers
Answer Posted / sn
it is a differential pressure transmitter
| Is This Answer Correct ? | 4 Yes | 14 No |
Post New Answer View All Answers
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
In Safe Guarding test what means by "Failed to Danger" ?
What are the interlocks we have to check during the start up of LP/HP compressor?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What is the use of control cable?
Difference between ultra sonic flow meter
What is motion balance principle?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
How many ohms are required for proper earthing?
What is the reason PT speed not incresed in gas turbine?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
Explain signal isolator
can you provide me full detail about instrumentation in ONGC??
