Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the motor winding resistance ?
- 21 Answers
- 122785 Views
- Forbis, L&T, OEGI, VTI, I also Faced
- E-Mail Answers
Answer Posted / muhammad kamran
although ohm-meter test is thorough enough but its not
complete...to find true result 1st ohm-meter reading is
taken and then in 2nd step a low voltage ac signal is
applied (using step-down transformer)normally 6:1 of
original operating voltage both voltage and current is
taken and Z-l(total impedence is taken) as unit is
performing in ac region not dc while ohm meter is dc
test.... why use this test?
not always the clear result is given by ohm meter test. a
winding may show balance state by ohm-meter but any
irregularity can be detected by AC-impedence test to be sure
| Is This Answer Correct ? | 14 Yes | 15 No |
Post New Answer View All Answers
can some one clearly explain why -48 volt DC use in telecom site????
What is safety of Ht panel
how can i get an electrical c-certificate?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
Work done in a free expansion process is
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
what is the difference between earth leakage and earth fault?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
Why is back emf used for a DC motor? Highlight its significance.
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
what is the difference between gas group b and gas group c electrical equipment construction wise?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
