What is the calculating formula for HT and LT amps in a
transformer.
- 22 Answers
- 143422 Views
- Cipla, K-Electric, I also Faced
- E-Mail Answers
Answer Posted / mukul tyagi
V*I(HT SIDE)=V*I(LT SIDE)
| Is This Answer Correct ? | 53 Yes | 27 No |
Post New Answer View All Answers
how to calculation increase power factor for single phase
How to minimize the eddy current losses?
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What is Fire Panel ? How it works ?
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
what is High resistance grounding and whatis the criteria for the selection of High resistance grounding
Can u tell me design of switch yard
how to calculate earth fault relay current and CBCT ratio
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
and gate circuit diagram,amplifier circuit diagram
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
Can i use the B-curve MCB instead of C-curve MCB
