why we are not earthing ht cable at both the ends(sending &
receiving end)?
Answer Posted / gunasekaran
if we connect at both end circulating current will flow so
Armour getting heated up if and then it will tripping for
earth fault protection.
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
Why do we avoid electrical conduits in floors at apartments?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What is Anemometer used to measure?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
Why is the starting current high in dc motor?
bitumar
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
What is difference between Harmonic and Non harmonic Capacitor Bank?
What is the unit of magnetic flux density?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
What is time invariant system?
What is the difference between alternator and generator?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??