Interested to Buy Any Domain ? << Click Here >> for more details...
what is phase to phase fault? what is line to line fault?
- 6 Answers
- 30895 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashwin
There are basically 4 types of fault
Symmetrical fault is
1. 3phase fault and
Unsymmetrical faults are
2.Line to ground fault,
3.line to line fault and
4.line to line to ground fault.
Phase fault occurs when one of the line falls on any ground structure.
line to line fault occurs when any two lines of the 3 come in contact with each other without any physical contact with the ground...
Phase to phase fault occurs when any two lines of the 3 come in contact with the ground structure, in other words phase to phase fault is line to line to ground fault.
Correct me if I am wrong..
My email id is : tarus_cool@yahoo.co.in
| Is This Answer Correct ? | 15 Yes | 5 No |
Post New Answer View All Answers
What aturn on methods of scr?
Cb closed condition if there is a tcs fail whether cb will trip or not
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
Do inductive loads have distorted current waveforms ?
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
Compare jfet’s and mosfet’s.
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
how to check three phase motor torque value?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
what is the difference between vector scale and vector diagram?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how unidirectional torque is produced in DC motor?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
Difference between control junction box (cjb) and power junction box(pjb)?
