Interested to Buy Any Domain ? << Click Here >> for more details...
hi i'm an Instrumentation student,i have one doubt that we
can call-
> computer science as CS
> Information science as IS
> Electronics & communication as E & C
In the same way what is short term for Instrumentation....?
- 11 Answers
- 13397 Views
- I also Faced
- E-Mail Answers
Answer Posted / d4rkhowl
I&C = Instrumentation and Control, Instrumenation field
dealing mainly with control systems such as PLC and DCS,
Programming, Etc.
I&E = Instrumentation and Electronics/Electrical,
Instrumentation field dealing mainly with field instruments
and their installation and maintenance.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
give me all the details about the interview and which type of question being asked
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
Exothermic reaction./ endothermic reaction
How oil line flow measured?eplain about instruments used and working principle?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
what is stroke check for field instument transmetter's & AOV's
How to calibration a control valve?
How to calibrate Magnetic flow Transmitter in Field
What is instrumentation instrumentation engineering?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
what is the input of digital counter during the the calibration time?
