parallel operation for tansformer which condition fill fil
for that
- 11 Answers
- 10031 Views
- ITC Infotech, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / ashok
1)polarity will be same.
2)phase sequence must be same.
3) turns ratio will be same.
4)impedance will be same.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the relationship between current&voltage in practical purpose ?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
block diagram of 2 ups system connected in hot stand by mode?
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
which of the following elements is not present in stainless steel
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
how invertor convert the dc into ac give brif detail
how to check three phase motor torque value?
Why two phase welding machine is used instead of three phase welding machine.
What is acsr cable and where we use it?
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
can any one know is sbi interview based on merit or based on roll number
