what are the standard values for resistances(Megger testing)
between L&N, L&E and N&E (L=Live,N=Neutral, E=Earth)?
- 1 Answers
- 9101 Views
- I also Faced
- E-Mail Answers
Answer Posted / pswin
You ask the value between L,N and E. So I will assume that you will test for single phase and the test voltage must be 500 v scale and full scale is 100 mega ohm.Minimum value should be 0.5 mega ohm between each conductors. If lower than that value, the cable or wire is not certified to use. For three phase, above answer is acceptable,too.
| Is This Answer Correct ? | 16 Yes | 3 No |
Post New Answer View All Answers
how the aircraft outer body and inner body is separated ?
Why increase in current leads to increase in conductor temperature?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
what do you mean by every IC 74 first digit.why are you using this no.why not using another no.
State angle criterion.
Define piezo-electric effect?
i want to know d working mechanism of tafe tractors next i like to know d engine type of apache bighs can anyone help me
how you configure motorvision relay (L&T make)from DCS
Why single phase induction motors are not self starting ?
what is the voltage between earth to neutral in lift.
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
