What loads the lagging and leading effects comes in a
circuit?
- 5 Answers
- 12140 Views
- I also Faced
- E-Mail Answers
Answer Posted / kandhavel.u
The lag and lead are produced by capacitive an inductive
behaviour of the conductor.the wire has all capacitys like
resistance,capacitace and inductance.based on these it
produces a difference in the phase between the I and
V.which we call the lag or lead.But Lag and Lead are what
the I goes with respect to V so depending upon the I's
position we state that as lag or lead.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Explain what is use of lockout relay in ht voltage?
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
list the type of vfd? wich is sutable for heating kiln?
what is the formula for computing cable tray size & capacity
What are the different methodes for calculating the short circuit Current?
why asa method ZPF method is more accurate than ASA method?
how can you calculate fault level ?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
When we use 3 terminal resistor?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
