Interested to Buy Any Domain ? << Click Here >> for more details...
what happen ,if generator will generate leading power
factor?
- 6 Answers
- 17188 Views
- CD, NTPC, I also Faced
- E-Mail Answers
Answer Posted / percy
It depends on the type of load
if its genteration is highly leading then line reactors are
switched on
under exitation may also drive generator in leading p.f.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
harmonics filter
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
what is the reactive power what is the use of it in system
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
How to minimize the eddy current losses?
which type of effect of turbine and generator reverse power protection ?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Under wat condition statcom operates as an inductor for the transmission line?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
What is step signal?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
How you will determine the volume of oil in a particular Distribution transformer.
