Hi,
I am littl bit confused about ip Addressing scheme? can
someone tell me how can we assign ip addresses to pc
- 2 Answers
- 4162 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera sinha
ok here is the answer
befor assing ip address you have to determine that what
class of ip you are going to give to your pc
for classs mask
A 255.0.0.0
B 255.255.0.0
c 255.255.255.0
here i assumed that you know about ip address classes and
its range
now how to assign ip address to your pc
go to
control panel---------click on network connection------
rightclick on you lanconection-----------go to properties---
--------go to tcp(last one)--------click on propreties tab--
---------------- assighn ip address(manualy)-----mask will
come atomatclay-------------defaultgateway should be used
and depedet upon your swtic/firwall/router conf.commenly we
use x.x.x.1 herer x is you ip claxx digit
if you donot know any thing abou default gate way
click on atomatic ip address button and dns server ---------
--------------click on ok--------------------click on close
thats it
my hooby is providing answer here so plz plz plase miore
prob
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is Bandwidth capping
What is the function of a router?
Can you explain encapsulating, carrier and passenger protocol?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is formula of hold down time of eigrp protocol?
What is Transport and Tunnel mode?
How many types of ethernet?
What is a Frame Relay?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
What are 10base2 ethernet lans?
Which protocols are link states?
Define routing?
Name the protocol which can do load balancing on unequal cost also?
What is the icmp protocol?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
