what is the significance of tan delta testing?explain the
theory?
- 7 Answers
- 35217 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.r.shah
Tan Delta is an effective tool in determining the
insulation condition of power cables using a VLF-TD System
Tan Delta measures the resistive component of a cable
system; a perfect cable is all capacitance and has no
resistance. The resistive component is caused by voids in
the insulation, electrical trees, water trees etc. The
resistive element causes the current not to lead the
voltage by 90° (something less) This is difference in angle
(less than 1° ) is the loss angle. The tangent of this loss
angle is the Tan Delta / or the tangent of the loss angle.
Thanks for Marking this Answer
| Is This Answer Correct ? | 29 Yes | 4 No |
Post New Answer View All Answers
What are the different methodes for calculating the short circuit Current?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
What happens to voltage when current is zero?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
can u please mail me the syllabus for GET exam for damodar valley corporation?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Tell me about ur past electrical maintanence job
What is the meaning of 40X8X2 busbar dimensions for carring load of 400 Amps
What is the numerical quantity of sqcm?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
