Interested to Buy Any Domain ? << Click Here >> for more details...
during parallel operation of two ac generator which
condition must match before taking both parallel i.e
speed /voltage rating /kva/exciation
- 2 Answers
- 9425 Views
- I also Faced
- E-Mail Answers
Answer Posted / pswin
Parallel operation of alternators is called synchronization. A synchroscope is an instrument for indicating the correct time for switching on. Three conditions must be fulfilled for synchronization.
1. Voltage must be same.
2.frequency must be same. And
3.voltage should be in phase position with respect to local series circuit.
Additional requirement is that the phase rotation must be the same.
| Is This Answer Correct ? | 27 Yes | 3 No |
Post New Answer View All Answers
how to calculate current and voltage in a same circuit?
briefly explain the main blocks found in a microprocessor based system
state the working of discharge lamp?
where are the circulat the diesel in DG parts name with pictue
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Define characteristics impedance?
What are the basic & Majour problems in UPS ?
What is Load sharing of Transformer ?
Earth bits close or open. Which is correct
tell me about roaster switch .& what is the function in transmission & distribution?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
how to calculate power consumption in slip ring motor at different step
What is the test block protection relay if any body know plz explained
