Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate busbar size & what is the procedure we
make for determine that?
- 35 Answers
- 216561 Views
- Auko Tex, Integra, PowerTech, Shadhin Group, I also Faced
- E-Mail Answers
Answer Posted / john philip
As per the load we have to calculat but we should choos a
good conducter with low resistenc value
| Is This Answer Correct ? | 11 Yes | 16 No |
Post New Answer View All Answers
A jet of fluid strikes a plate What was the force required to counter it?
Is there chopping current in resistive circuit
how much GROUND & NEUTRAL VOLT maintain in data center.
Define settling time.
Why use in ht motore
How to decide whether A / B / C / D curve type MCB should be used?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
why does a dc machine has high efficiency while working as a generator than as a motor ..
How to megger test 11 kV cable and the acceptance IR value
full form of electrical?
Why reactors use before incoming of ac vvfd drive?
How many types of faults are there in 3 phase power system?
why dc is used in control circuit for mv & hv switchgear instead of ac
What will happen if the d.c. Machine is operated below rated speed?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
