WHY FLEXI LINKS ARE USED INBETWEEN GENERATOR TERMINAL
OUTPUT & BUS DUCT CONDUCTOR.
- 3 Answers
- 4928 Views
- I also Faced
- E-Mail Answers
Answer Posted / shali
That have also something to do with avoiding high tenssion
on the generator terminals due to the physical weight of
the hard busbar. Plus, limiting the transfare of the
generator vibe to the bus.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how generator load test is conducted?what are the steps?
for compensate 315mh inductance ,how many capaciance required?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
what is load vs Torque curve & why it is used?
how to calculate the no load current in transformer?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Discuss about gear cutting machines.
what is different between relay and plc?
why co incidence factor considered in transformer sizing?
