Interested to Buy Any Domain ? << Click Here >> for more details...
i have D.p. transmitter of range 0 to 2540 mmWC, i want to
use this for flow measurement (0 to 500 ltr/hr.) what
should i do?
- 9 Answers
- 25081 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjay
by creating proper DP across orifice plates we can measure
flow rate also change the SQRT property in x-mitter
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Calibration procedure for electro magnetic flow meter
Which products are available in the Mass Systemswitch and System Manager AC range?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
what is interface level and how it is calibrate?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
what is compensation? temprature & pressure
what are procedure of sox-nox calibration
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
2. What is ultrasonic flowmeter?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How can you add value to this Industry if offered the job?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
