the distance from my office to d.g is aprox 400mtrs and
voltage drops ibn my office near about 40 volt what should
i do p[ls suggest.
- 6 Answers
- 5340 Views
- I also Faced
- E-Mail Answers
Answer Posted / ps win
(+ or - 4% of nominal voltage can be acceptable.)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
What is meant by positive and negative feedback?
Write down the name of 2 lady Bir Pratin of Bangladesh
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
what is the carona effects meaning in HT line transmmission system
What are the three types of compensators?
Brief me about maintenance planning & sheduling of machine tool.
when it is possible kvrah lead & fundamental kwh be equal in electonic trivector meters (3 ph)
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
what is the write prosidure of stringing of 8meter pcc pole.
